Canopy backhaul module bh user manual

Backhaul User Manual Issue 3 Page 3 of 53 Backhaul with Reflector to GHz mW RMS 63 Watts EIRP High Index 2-level or 4-level FSK to MHz in 5 MHz increments 20 MHz Canopy can be configured to operate at a range of frequencies, but at this time, only channels from MHz through MHz of the. SM User Manual Issue 3 Page 3 of 33 Backhaul with Reflector to GHz mW RMS 63 Watts EIRP High Index 2-level or 4-level FSK to MHz in 5 MHz increments 20 MHz Canopy can be configured to operate at a range of frequencies, but at this time, only channels from MHz through MHz of the. The Canopy. Backhaul (BH) must be installed to provide a separation distance of at least 20 cm ( in) from all persons. When adding the Canopy reflector dish, the reflector dish must be installed to provide a separation distance of at least m ( in) from all persons and does not emit RF field in excess of Health Canada limits for the.

Each BH Module receives its 24VDC power from a power supply (ACPS Configuration Guide. or ) or the 90VV switching power supply (ACPSSW) and associated RJ45 connector. The BH Module can also be connected to the CMM, which will supply power to the BH Module and networking with the AP Modules at the AP Cluster. For more information about the BH, see Canopy Backhaul Module (BH) User Manual. For more information about the SM, see Canopy Subscriber Module (SM) User Manual. TYPES OF AP APPLICATIONS APs and SMs are available in GHz, GHz, and GHz frequency bands. Due to regulatory agency restrictions, a GHz SM cannot be used with a. Access Point Module BH Backhaul Module, either timing master or timing slave BHM Backhaul Module - Master BHS CAP CIR Backhaul Module - Slave Access Point Module Committed Information Rate CMM Cluster Management Module (CMM4 or CMMicro) CNUT CSM Canopy Network Updater Tool Subscriber Module DES DFS DHCP DiffServ Data Encryption Standard.

matching ports within the Canopy Cluster Management Module. o A total of 8 ports are available on the Canopy Cluster Management Module, to accommodate 6 Canopy Access Point Modules and 2 Canopy Backhaul Modules. Route the GPS sync (serial) cables from the Canopy Backhaul Modules, if necessary, to the Canopy Cluster Management Module. For more information about the BH, see Canopy Backhaul Module (BH) User Manual. For more information about the SM, see Canopy Subscriber Module (SM) User Manual. TYPES OF AP APPLICATIONS APs and SMs are available in GHz, GHz, and GHz frequency bands. Figure The Canopy MHz Subscriber Module with Connectorized Antenna Figure The Canopy Backhaul (BH) Modules Figure The Can, or Mbps Backhaul (BH) Module with Integrated.